Tea urn wax melter3/11/2024 Ideally, a wick should be trimmed to 1/4 to 1/3 of an inch. Alternatively, the wick may have simply been trimmed too short.Ī very small blue flame is typical of a wick trimmed too short. The picture shows that the flame is a good size but since the melt pool hasn't reached the sides, it is possible that the wick could be slightly too small for this particular jar/recipe combo. That is not a problem in the first picture below. If the melt pool doesn't spread across very much and the candle begins burning straight down (called "tunneling"), then that is a sure sign that the wick is too small. It's good that the melt pool has almost reached the edge of the jar. At this point (when the picture was taken), it might be a little early to tell. This candle is likely wicked about right or possibly with a wick slightly too small. Into consideration the type of wax, jar size, and additional additives) will This will be noticeable because the burn pool will not reach the edges evenĪfter several hours and most times, the wick will just burn out from lack ofĪ candle that is wicked appropriately for the recipe (taking Is too small for the container, it will not be big enough to “pull” the mixture of ingredients (wax andįragrance/dye/additives) up the wick to create proper combustion. There can be a couple of reasons for this.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |